January 20, 2021
There I said it – I am not fan of epoxy, flox, micro and sanding. My day was kicked off with 150 minutes of sanding and cleaning up. But the cabin top was to be installed! Whew. Next up was finishing up the door prep. Those door pins, filing the correct amount off the ends of the rods to get…
January 19, 2021
Big progress on the cabin top today. I figured out a way to apply micro to the vertical surfaces which greatly reduced the waiting time. All told today I major sanded twice and applied micro three times. I think after tomorrow morning’s sanding session I should be ready to attached the cabin top to the airframe! Also up today was…
January 18, 2021
So I started the cabin top fairing this morning, which meant three hours of sanding. The raw fiberglass out of the Van’s mold is wavy and full of fabric patterns so it was go time. That was a fun morning. I got a layer of micro laid down on the flat top section and put a first coat to smooth…
January 16, 2021
Sooo, I finished up the sanding/priming of the right elevator trip fairing before moving on to wiring the overhead console lights. I needed to get the console finished so it could be attached to the cabin top. This meant putting in the eight single lug nutplates that I had to order way back when I last worked on attaching the…
January 15, 2021
Seems I will be living in the world of fiberglass and epoxy for awhile. The engine cowling hinges are now all drilled, this took two people – one to squeeze and one to drill. After all the filling of the sides and back there is poor alignment on the front corners. Got a layer of flox down to start filling…
December 8, 2020
I decided I needed to make some adjustments to the mounting brackets for the transponder which morphed into giving all of the support brackets a good paint job. That along with a little more work on the baggage door took up a good chunk of the morning. After lunch I ran two cables I had forgotten for the overhead lights…
November 18, 2020
Finished up cutting the holes for the defrost fans (2 of 2) which went quick and then it was on to the day’s major effort – cutting/sanding carbon fiber. First I took on the vents on the panel which was a warm up to the overhead console. The console had four vents which weren’t too bad other than a lot…