November 22, 2020
Man, today was a day that was an uphill climb. Right off the bat, when I removed the air valve used to leak test the tank the Loctite 515 made it stiff. Removed, I used acetone to try to cleaning the bung fitting. Then I screwed in (temporarily) the new AD4 fitting – mistake. This messed up the threads. Ugh,…
November 21, 2020
Started with crimping the BNC connectors for the ELT antenna and the COM2 antenna before moving back wheels. Oops, started the fuel tank pressure testing on the right side. Made Lee’s suggested plates on the wheel pants bracket and got them glued on. Tomorrow I will add some rivets and then do the final assembly of the mains. Then it…
November 17, 2020
I was so looking forward to getting the wheels on today. Landing gear installed – check. Tires, tubes, rims ready to go – check. Assembly, fuck me. Learned today that Matco wheels don’t use standard tubes. The hole for the valve is offet about an inch. Blerg, new tubes on order. On the positive side, ProSeal the bungs for the…
November 11, 2020
Started with making a vacuum adapter for sucking the metal flakes when drilling the holes for the main fuel tank bung. Drilling went well but I did spend about 45 minutes deburring, vacuuming, and cleaning the tanks. I think and hope I got everything. Then it was on to installing the ER tank fuel pumps, once I deciphered how everything…
November 6, 2020
Laying in bed last night what pops into my mind but that I forgot to pull the wire through the wings for my extended range fuel tank pumps. Ugh, that could have been a pain. So guess what I started my day doing… Reading through the instructions and reviewing the excellent builders log by Robert Lussow I decided the tanks…
October 26, 2020
So I am learning the lesson on how long things take when you deviate from the plans. First, I have to say the past two days designing parts and figuring things out myself has been fun. But…it is very time consuming. Take the PH Aviation flap bracket. I chose to design something myself and I think I’m on design rev…
October 21, 2020
The morning started with priming parts for the Horizontal Stabilizer. Then an exciting step, hung the QB wings in the rack and got the aileron bracket and Garmin autopilot servo installed. A good chunk of the day was spent assembling the Horizontal Stabilizer Front and Rear spars. Quite a lot of riveting and even more to come. But my riveting…