January 26, 2021
Whew, big day with lots of progress. Kicked it off with cutting holes for the defrost fans in the glaresheild. Friday is hopefully the day to install windows and it needed to be done before then. Then it was on to fabricating the door lock brackets. Not too difficult but one has an odd bend to match the door that…
December 10, 2020
Took some time but I got all the nut plates for the instruments installed and the instruments mounted. Also got the defrost fans installed, wired up, and tested. Then it was on to the baggage and rear seat pans. All the parts are now dimpled and deburred. Still nervous about a missed wire so I’ll hold off on riveting them…
November 18, 2020
Finished up cutting the holes for the defrost fans (2 of 2) which went quick and then it was on to the day’s major effort – cutting/sanding carbon fiber. First I took on the vents on the panel which was a warm up to the overhead console. The console had four vents which weren’t too bad other than a lot…
November 17, 2020
I was so looking forward to getting the wheels on today. Landing gear installed – check. Tires, tubes, rims ready to go – check. Assembly, fuck me. Learned today that Matco wheels don’t use standard tubes. The hole for the valve is offet about an inch. Blerg, new tubes on order. On the positive side, ProSeal the bungs for the…