January 31, 2021
Oh I’m sure something will pop up but this morning I finished the wiring behind the panel and was happy to see the autopilot servos were detected, firmware automatically updated, and the looked good. I may have accidentally run the aux fuel tank pumps for a second, so I know those work too. I still need to wire the wing…
January 4, 2021
Late start today but still made some good progress – started with tightening the jam nuts and torque sealing the Elevator push/pull tubes. Then I fabricated an additional rudder cable guide and got it installed, followed by reorienting the rudder cable/pedal bolts to give more room from the rear seat scat tube and bent over the cotter pin in the…
December 31, 2020
Short day today. Adjusted the Elevator push/pull tubes which was a good exercise as I disassembled the front tube to check the thread length on each end. With the Tosten stick grips I cut down the sticks as low as possible and then set the best Elevator Up/Down to the best range. Installed Tosten stick grips and tightend all hardware…
December 30, 2020
For real, I think the spar tunnel is done until the wings go on… Started off adding connectors and drilling brackets made by fellow builder Leo for a set screw need to keep the Tosten stick grips from spinning. Then moved back into wiring mode to work on the connectors that stick grips plug into. That took awhile… Also soldered…
December 3, 2020
Today was spent finishing the nutplates on the wings for the wing root fairings and then back to electrical work. All of the rear plane electrical was completed along with the antenna connectors. Then moving forward I added snap bushings and adel clamps to the 2AWG power cable and finished off the cable with the terminal to bolt it to…
October 25, 2020
The day started with three hours of finishing the Elevators. Whew, this section too quite a bit more effort than I had expected. Will be interesting to see how long the Horizontal Stabilizer takes to assemble/rivet… From there, assembly of the aileron push tubes and aileron roll trim bracket. Fabrication of new brackets for the PH Aviation flap actuator. Started…