Saildrives: Difference between revisions
No edit summary |
No edit summary |
||
| Line 19: | Line 19: | ||
# Refill oil to full capacity (bottom of dipstick)<br> | # Refill oil to full capacity (bottom of dipstick)<br> | ||
:(This will replace over 75% of the oil)<br><br> | :(This will replace over 75% of the oil)<br><br> | ||
Outer diaphragm and secondary inner diaphragm<br> | Outer diaphragm and secondary inner diaphragm<br> | ||
''Replacement Guidelines:'' Inspect every 2 year and replace every 5 years<br> | ''Replacement Guidelines:'' Inspect every 2 year and replace every 5 years<br> | ||
''Common Practice:'' Monitor condition and test the water penetration sensor<br> | ''Common Practice:'' Monitor condition and test the water penetration sensor<br> | ||
''Recommendations:'' Pacwest in San Diego does not recommend changing the diaphragms unless there is visible damage or water has penetrated the outer diaphragm. These diaphragm almost never fail. I have read this from other sources who make the same recommendation. | ''Recommendations:'' Pacwest in San Diego does not recommend changing the diaphragms unless there is visible damage or water has penetrated the outer diaphragm. These diaphragm almost never fail. I have read this from other sources who make the same recommendation. | ||
Propeller Shaft Grooves<br> | |||
It is an issue that they Gori propellers installed on a SD20 saildrive will form grooves over time which will result in sea water penetration. Periodic repositioning of the seals using shims allow longer life from the propeller shafts.<br> | |||
[[File:Propeller Shaft Seal Grooves.jpg|thumb|Grooves worn into the propeller shafts]]<br> | |||
Revision as of 13:19, 4 May 2026
Manufacturer: Yanmar
Description: Saildrive Unit
Model: SD20
Manual: File:SD20 Operations Manual 2009.pdf
Parts catalog: File:SD20 Part Catalog.pdf
O-Ring parts diagram: File:SD20 O-rings Parts Diagram .pdf
Service Bulletin - Taper pin: File:SD20 Taper Pin Bulletin.pdf
Notes:
Blown seals: The SD20 is suspetible to blowing the seals if the oil is filled too high. Many have added a vent line to the top of the filler cap. Without the vent, only fill the saildrive oil to the bottom of the dipstick
Oil change interval: Every 250 hours of operation or annually (whichever comes first)
Oil: 80W90W gear oil (API GL-4 or GL-5)
Oil capacity: 700ml
Oil change in the water:
- Using a pump with a small tube remove as much oil as possible
- Refill oil to full capacity (bottom of dipstick)
- Run engine 5 minutes
- Using a pump with a small tube remove as much oil as possible
- Refill oil to full capacity (bottom of dipstick)
- (This will replace over 75% of the oil)
Outer diaphragm and secondary inner diaphragm
Replacement Guidelines: Inspect every 2 year and replace every 5 years
Common Practice: Monitor condition and test the water penetration sensor
Recommendations: Pacwest in San Diego does not recommend changing the diaphragms unless there is visible damage or water has penetrated the outer diaphragm. These diaphragm almost never fail. I have read this from other sources who make the same recommendation.
Propeller Shaft Grooves
It is an issue that they Gori propellers installed on a SD20 saildrive will form grooves over time which will result in sea water penetration. Periodic repositioning of the seals using shims allow longer life from the propeller shafts.
