February 2, 2021
Wow baby, that was a bigger pain than one would think. Lots of nutplates – check. Metal forming – check, minimal room for riveting – fucking check. Only had to drill out two nutplates that interfered with the rivets to the fuselage, that would have been nice to note in the manual. Yep, I’m a little salty. Still remaining is…
February 1, 2021
So yesterday I spent over an hour trying to figure out why the brakes were dragging. Today I was committed to solving this drama. I took the brakes apart again. This time I found that the bolt holding the brake assembly to the axle had an interference issue. Why was this not in the manuals??? Still the rear pad was…
February 1, 2021
I ended up with some excess wire left over but not an obscene amount. The table below shows all of the wire I purchased for my build and was used to complete 100% of the wiring in my plane